Cattle trough 1120274

steelinteriorexterior

Hot-dip galvanised. Due to the aggressiveness of the lactic acid naturally present in silage, the zinc coating (Galvanised) can deteriorate. To extend the feed trough’s service life, a bituminous coating (e.g. Blackson food grade) needs to be periodically applied to the inside of the trough - Manufactured from 2 mm sheet steel bent in a single length for greater rigidity, - Angles are notched allowing the ends to be superimposed with a weld bead for more solidity, - Anti-rust protection on the entire trough, - Polyurethane paint applied on pan interior and exterior, - Very deep trough pan, - Base smaller than trough width. Standard feed troughs are fitted with: - 2 reinforcing cross bars inside the feed trough, - 4 feet welded under the tray for troughs up to 5 m and 6 feet for 6 m. Feet connected by reinforcing cross bars. - Anti-spillage rim’s width of : • 75 mm for any troughs width from 0.80 to 1.50 m • 55 mm for troughs width 0.60 m, - Ø 50 mm galvanised legs for any troughs width from 0.80 to 1.50 m and Ø 42.4 for any troughs width 0.60 m. Adjustable in height in groups of 7 cm by a through bolt to adjust the height or tilt the trough to limit waste, - 1 PVC threaded drain through wall plug (Ø 45 mm). Standard painted and galvanised feed troughs are available in two widths: 0.80 and 0.60 m. They are intended for cattle for feed and silage. Hot-dip galvanizing after manufacture for protection.